Geemarc RP7510 User Manual download pdf (Page 6)

Setting up

Step 3: set the clock

The machine speaks. If you set the clock, the machine will announce the time and day that

each message was left.

What you need to know before you start

• Don’t leave more than 15 seconds between button presses. otherwise you’ll have to

start again.

• To programme a setting, you use OGM1 and OGM2. OGM1 takes you to a higher

setting; OGM2 takes you to a lower setting. The machine calls out the settings.

• Ensure MESSAGE DISPLAY is on. If not, press ON/OFF.

1 Set the volume to medium.

2 Hold down SKIP until the machine calls out ‘Sunday’. Then release SKIP.

3 Press OGM1 or OGM2 to set the day. Then press SKIP.

4 Press OGM1 or OGM2 to set the hour. Then press SKIP.

5 Press OGM1 or OGM2 to set the minutes. Then press SKIP.

The machine will call out your setting.

• To hear the setting at any time, press SKIP.

• To change a setting, repeat steps 2-5.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Geemarc RP7510 User Manual Page 6